RotoPaX Mount

Wide Diameter Range

Available in multiple diameter options to fit a variety of round tubular roof racks.

RotopaX Mount Ready

Works with RotopaX mounts and smaller cans using the single mounting hole layout.

Made In-House

Machined from USA-made aluminum and finished in black anodizing.

Compatible With

• Compatible tubular roof racks
• Round tube rack sections matching the selected clamp size
• RotopaX mounts and smaller RotopaX cans
• Many off-road, overland, and utility rack setups

Important Notes

• Measure your rack tubing before ordering
• RotopaX mount and cans are not included
• Larger 4-gallon cans may require additional mounts
• RTT clearance may vary by rack, vehicle, and tent setup

RotopaX Mount Plate
Machined aluminum mounting plate

Tubular Clamp Set
Clamp size based on selected option

Black Anodized Finish
Clean, durable aluminum finish

1. Measure your rack tubing
Use calipers or our printable measuring PDF to confirm your tube diameter before selecting a clamp size.

2. Select the matching clamp size
Choose the clamp size that matches your actual roof rack tubing. A slightly oversized reading is normal on powder coated racks, so a 1.75" clamp may be correct even if your rack measures slightly over 1.75".

Common reference sizes: 4Runner TRD Pro 2019–2024, FJ Cruiser 2007-2014, and Sequoia TRD Pro 2020–2022 roof racks typically use 1.75" tubing. GOBI Toyota roof racks typically use 1.00" tubing.

3. Check tent and accessory clearance
Verify that your rooftop tent, awning, crossbars, and other accessories will clear the RotopaX can once installed.

1. Position the clamps
Place the clamp halves around the tubing and position them where you want the RotopaX mount installed.

2. Tighten the clamps evenly
Gradually tighten all hardware a little at a time so the clamps seat evenly around the tubing.

3. Attach the RotopaX mount
Install your RotopaX mount using the supplied hardware and adjust as needed before final tightening.

4. Install your RotopaX can
Secure your RotopaX can according to the RotopaX mount manufacturer's instructions.